| introduction |
First, Use
This company produces the JGS-880/980 model multi-purpose bottle cap lock catches machine widely to be suitable for the glass, the plastic, the polyester bottle mouth metal security lid, the plastic security lid, the can, turns on lathe uncaps, aluminum sealing as well as spray nozzle this seal, rolls the spiral, to turn on lathe covers and so on productions. This machine contour is artistic, the rational design, the structure are simple, the ease of operation, the processing are precise, the maintenance is convenient.
Second, Main parameter and specification
1¡¢Modle JGS¡ª880 JGS¡ª980
2¡¢Jar altitude 70¡«330mm 20¡«350mm
3¡¢Closing up an opening scope ¦µ25-35mm ¦µ20-35mm
4¡¢Productivity 800Bottle/hour 1000Bottle/hour
5¡¢ Consumption 0.25KW 0.37KW
6¡¢Supply 220V¡¢50HZ 220V¡¢50HZ
7¡¢Weight 50KG 560*240*1150mm
Third, application method
1, the center and adjusts highly:
First places the jar has a haircut on, selects the electric actuator to cause the bottle cap to rise close in low spirits, the adjustment has a haircut causes the bottle cap one to tally in low spirits, contracts again has a haircut. When the bottleneck does not have the localization, the adjustment bias locates quick and has a haircut, causes the bottle cap center and the center tallies in low spirits. When jar isochronism, should not loosen highly goes against the tight bolt to move the central disk, causes it to satisfy the request, locks again goes against the tight bolt. After centering adjustment, drops to the machine the bottom (980 molding machines to again let lock climb to does top digit), surveys the end surface distance to be about 48 millimeters. If is dissatisfied, loosens the stop screw round nut, moves the lifter to carry on the adjustment. Finally tight stop screw round nut.
Attention: 1st, in the use process, must certainly lock goes against the bolt, because the central disk is been big the pressure, easy to shift; 2nd, when glass jar lock catch, may have a haircut the iron dismantles, exchanges the plastic to have a haircut.
2, rolls a silk round adjustment to place the jar has a haircut on, starts the machine, the fluctuation peak, loosens the stopping nut first, the readjustment copper core causes two to roll the silk round (to have spring) the edge the silk to light in the jar. Then loosens the regulating nut, in 2 adjustment adjusting screw, causes two to roll a silk round edge and the cover contacts and has the suitable pressure for suitable. Finally stopping nut and regulating nut.
3, closes up an opening a round adjustment during the adjustment rolls silk round, adjusts two lock catches round (non-spring), loosens the stopping nut first, the readjustment copper core causes two to close up an opening a round edge with to contact and to have the suitable pressure under the bottle cap for suitable, finally stopping nut and regulating nut.
Attention: When adjustment from the pine to now, the application moves the lock adjustment, by against lock broken bottle mouth.
4, the mineral water bottle cap turns on lathe the lid to loosen guides the bolt, turns on lathe the counter-thread clockwise the pressure lid (regarding 980, should take down reverse first in low spirits, then uses a character screwdriver fixed central shaft, then turns on lathe clockwise presses lid), takes down the entire lock. (Fitting) installs again the plastic lock in the rise puts on, the inspection beat cannot surpass 0.05mm, then adjusts the bracket to rise and fall the altitude, causes the plastic lock to lead plastic bottle cap revolving to complete tightens the seal the function.
Attention: Two guidance bolts cannot go against rise the wrap deadly. The plastic lock may move up and down. |
